Fitting godflex bushes - Help & Tips

---

 Help & Advice: 

Fitting Godflex Polyurethane Bushes:

Proper installation is essential to ensure the performance and longevity of your Godflex bushes. Please read and follow the guidance below carefully before fitting. Failure to follow these recommendations may result in premature wear or damage, which is not covered under warranty.

1. Check Sizing Before Installation:

Many Godflex bushes — including anti-roll bar, rear beam, and front control arms may have variants — are available in multiple sizes. It is the customer’s responsibility to verify that the correct size has been selected for their vehicle. If an incorrect dimension is chosen (e.g. too large or too small), this can cause play, binding, or premature fatigue. Godflex cannot be held liable for damage caused by incorrect selection or installation, and any applicable warranty or return claim may be void.

2. Greasing:

Where required, Godflex supplies the correct white silicone grease with each kit, and in many cases, bushes are lightly pre-lubricated before dispatch. Before installation:

• Apply the supplied grease liberally to the inner bore of each bush.
• If the bush has grease-retaining grooves, ensure these are fully filled.

Correct lubrication is essential for optimal performance, longevity, and to minimise noise, vibration, and harshness (NVH).

3. Torqueing and Fitting: 

When installing Godflex bushes:

• Fit the bushes with the vehicle safely supported on stands or a lift.
• Final torqueing of suspension bolts must be done with the vehicle at ride height (under its own weight).

This allows the bushes to sit in their natural position and prevents preloading. Torqueing components while the suspension is hanging can cause incorrect bushing alignment, resulting in premature wear or failure. After fitting, always carry out a four-wheel alignment to ensure the suspension geometry is correct and that no additional strain is placed on the new bushes.

4. Recommended Installation Practices:

We strongly recommend that all Godflex bushes are fitted by a qualified technician or by an individual experienced in polyurethane bushing installation.
Use the correct press tools and equipment where necessary.

Press-Fit (One-Piece) Bushes

For larger front control arm bushes and similar applications:

• Use a generous amount of dish soap to aid insertion.
• Ensure all old rubber and debris are removed from the housing.
• Smooth any sharp edges that could damage the new bush.
• When pressing, allow one side of the bush to enter first rather than attempting to press it perfectly square — this reduces stress on the top hats and helps avoid tearing.

(See diagram below for pressing example.)

5. Check surrounding components

When fitting new Godflex bushings, it’s important to inspect all surrounding suspension components to ensure they’re in good condition. Worn ball joints, tired control arms, damaged mounting points, or failing drop links can all place excess stress on fresh bushings, leading to premature wear or reduced performance. Before installation, check for play, corrosion, perished rubber, or any looseness in connected parts. Replacing or repairing these items at the same time helps the new bushings perform as intended and ensures a smoother, safer, and longer-lasting suspension setup.

6. Disclaimer 

Godflex components are manufactured to precise tolerances and tested for performance and durability. Correct selection, preparation, and installation are the responsibility of the installer.

Improper fitment, incorrect torqueing, or failure to follow the above guidelines may result in premature wear or damage, which is not covered under warranty.